JUNO
If anything, I like the steam dredger more than Juno, but in any case a very nice pair of models. Dean, you should be very proud of them both.
Nerys
Nerys
When the winds before the rain, soon you may make sail again, but when the rain's before the wind, tops'l sheets and halyards mind
Gostado por Martin555
JUNO
Hi Phil,
Looks like you will be passing on more complements.
Dean has done it again, excellent Job, well done,
Martin555.
Looks like you will be passing on more complements.
Dean has done it again, excellent Job, well done,
Martin555.
If it looks right it probably is.
JUNO
What a nice boat especially as she is built from recycled etc materials. Looks like a refuelling barge or river tanker. Excellent attention to detail. Well done Dean.
Nerys
Nerys
When the winds before the rain, soon you may make sail again, but when the rain's before the wind, tops'l sheets and halyards mind
Gostado por Martin555
JUNO
Info from Buxton Model Boat Club member and builder Dean.
Juno is quite a basic flat bottomed boat, mainly due to my very basic modelling skills, and is intended to be a bunkers barge. She is roughly 1.24 scale, approximately 43 inches by 8 inches and is made from recycled and up cycled materials wherever possible. She has a single rudder and propeller, powered by a single motor from a drill, and two 6v lead acid batteries.
She is a totally freelance design, but I took inspiration from Humber barges such as the Humber Princess, which I used as a rough plan for the deck layout.
As a foot note to Juno, when I built her, I also built a second hull at the same time almost identical, but with a different deck layout. This became Elsa, my steam dredge barge.
Juno is quite a basic flat bottomed boat, mainly due to my very basic modelling skills, and is intended to be a bunkers barge. She is roughly 1.24 scale, approximately 43 inches by 8 inches and is made from recycled and up cycled materials wherever possible. She has a single rudder and propeller, powered by a single motor from a drill, and two 6v lead acid batteries.
She is a totally freelance design, but I took inspiration from Humber barges such as the Humber Princess, which I used as a rough plan for the deck layout.
As a foot note to Juno, when I built her, I also built a second hull at the same time almost identical, but with a different deck layout. This became Elsa, my steam dredge barge.
phil
Gostado por Joe727 and MouldBuilder and
Gostado por
A carregar…